|
|
|
 Look at the success of the Banebot's gearboxes this year. Cheap, light, small, and a lot of people are using them, even though their quality may be a bit questionable... Make a similar gearbox for a drivetrain (with a bit more robustness) and I think you've got a winner. - Ben Piecuch [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
01-03-2012, 12:10
|
|||
|
|||
|
Re: Getting data to the dashboard
Steve, I hope you are Ok if add to your question...
I did the tutorial Alan suggest, worked fine. I would like to eliminate some info/controls not to dash, TCP error night mares in past... When I delete Analog/ Digital on dash, of course get errors in code, need clean up. Alan - others Can I just delete control and try and eliminate errors in VI until they are gone, or is there a better method? Do not want to create problems by trying to prevent them, want limited info sent back if not needed. thanx mark 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode