Rookie Team Passing Inspection (video)

[Jaxom]

Originally Posted by sandiegodan

I inspected in San Diego and I didn't see any of that particular issue. It was mostly about the 8" minimum supported bumper from the vertex when the bot had a ball opening on the narrow end of the frame.

The bumper issues I remember were almost all this 8" problem, although we also had a few with numbers that didn't meet the rules.

I did have one robot I inspected that had to add an attachment when they went from a 6" to a full 8" section at the side of their opening. There was only one attachment on the original segment & it was closer to the corner than it was to the opening; adding the extra 2" would have left a pretty wobbly bumper without a 2nd attachment.