Auto Code NOT Running (as expected)

[RufflesRidge]

As long as you have not modified Robot Main, the Autonomous Independent VI will be automatically terminated when the robot changes modes, regardless of whether it is currently "caught" in a loop or not.

[kws4000]

Would passing Ultrasonic and Joystick data to the Dashboard inside Robot Main qualify as "modification"?

[RufflesRidge]

Originally Posted by kws4000

Would passing Ultrasonic and Joystick data to the Dashboard inside Robot Main qualify as "modification"?

Nope, that should be fine.

[kws4000]

Annnddddddddd, (drum roll please)

It doesn't work. Error #-44061 at Leftand Right Motors, standard loop starvation code. The joystick z-throttle selector works.

We have a loop around all Auto Code, with a Wait in there of 20, and tried again w/ 50. Loop starvation every time!

Also, sending kinect2 yaxis back to dashboard. Always sends "0", even when doing the floppy chicken!

So therefore, is it some error in setting up the Kinect, or can the robot not reliabley interpret the Kinect data?

[RufflesRidge]

Originally Posted by kws4000

Annnddddddddd, (drum roll please)

So therefore, is it some error in setting up the Kinect, or can the robot not reliabley interpret the Kinect data?

If you run the default dashboard, does the Kinect "green man" and Y-axis data show up?

[kws4000]

Originally Posted by RufflesRidge

If you run the default dashboard, does the Kinect "green man" and Y-axis data show up?

yep. The little bars work fine, but the robot won't reliably read the kinect and sentd that data back to a custom readout, and yes the indicator works properly just like the other 2 windows we have right above it.

I think if the dashboard can finally get the proper data, then the robot auto code will work fine.

[Mark McLeod]

Originally Posted by kws4000

Also, sending kinect2 yaxis back to dashboard. Always sends "0", even when doing the floppy chicken!

So therefore, is it some error in setting up the Kinect, or can the robot not reliabley interpret the Kinect data?

By any chance do you have the Driver Station I/O Tab set to Enhanced Mode without the Cypress connected?

That's a unique case (bug) where the Kinect data will not get sent properly to the robot, but will be seen just fine on the Dashboard Kinect skeleton feedback.

[kws4000]

Originally Posted by Mark McLeod

By any chance do you have the Driver Station I/O Tab set to Enhanced Mode without the Cypress connected?

That's a unique case (bug) where the Kinect data will not get sent properly to the robot, but will be seen just fine on the Dashboard Kinect skeleton feedback.

That may be it, Mark. We'll try it either tomarrow or Wednesday, we may be doing something with team Wavelength in Norton Shores.

Otherwise, code looks good? If it ain't, I'll never hear the end of it!