Auto Code NOT Running (as expected)

[Mark McLeod]

Originally Posted by kws4000

Also, sending kinect2 yaxis back to dashboard. Always sends "0", even when doing the floppy chicken!

So therefore, is it some error in setting up the Kinect, or can the robot not reliabley interpret the Kinect data?

By any chance do you have the Driver Station I/O Tab set to Enhanced Mode without the Cypress connected?

That's a unique case (bug) where the Kinect data will not get sent properly to the robot, but will be seen just fine on the Dashboard Kinect skeleton feedback.

[kws4000]

Originally Posted by Mark McLeod

By any chance do you have the Driver Station I/O Tab set to Enhanced Mode without the Cypress connected?

That's a unique case (bug) where the Kinect data will not get sent properly to the robot, but will be seen just fine on the Dashboard Kinect skeleton feedback.

That may be it, Mark. We'll try it either tomarrow or Wednesday, we may be doing something with team Wavelength in Norton Shores.

Otherwise, code looks good? If it ain't, I'll never hear the end of it!