|
|
|
 My sister's husband told me when I was just a wee one, "momentum will take you where traction will not." - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| My sister's husband told me when I was just a wee one, "momentum will take you where traction will not." - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Cypress Board Config
I know the Cypress board came with some kind of software for use with programming it, is this necessary, or can I just connect my buttons, dials, leds, ect. to it and configure it in my code and have it work fine?
Just got back from our Regional and wanted to start thinking about next years control/operator console. 
|
|
#2
20-03-2012, 19:57
|
||||
|
||||
|
Re: Cypress Board Config
Yes, the PSoC Programmer is required at least once because FIRST writes a .hex file to the Cypress Board that allows it to interface with the DriverStation via the IO tab. When you go to image the Cypress board the .hex file should be located in the public users documents in a folder called FRC
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Programmer - A creature known for converting Caffeine into Code.
Linear Mode
