|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: Programming Pneumatics in Labview
I think you mistyped and really have the compressor Spike wired to Relay 1 on the Digital Sidecar, not far from the pressure switch that's in DIO 1.
The spike does NOT plug into the solenoid breakout, only the solenoids do that. To run the compressor: ![]() To fire the solenoid: ![]() Last edited by Mark McLeod : 20-03-2012 at 19:16. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|