Colson 101 - Chief Delphi

In the end, we were successful, but the tale is one of such stupidity that it should be engraved in drool upon a failed math test. - AmLameBro [more]

		Chief Delphi > Technical > Technical Discussion
Colson 101

Thread Tools

Rate Thread

Display Modes

#29

27-03-2012, 15:51

Andrew Lawrence

Posts: n/a

Re: Colson 101

Quote:

Originally Posted by JesseK

How would one go about cutting the diamond pattern in the tread like what Art posted?

Conceptually, I can think of a way to draw the pattern on the wheel and then use a mill -- but is there a more efficient way to do it?

Also, how deep should the pattern be?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:40.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.