Crio windriver programming problems

[programmerB]

where is the Netconsole located?

[bob.wolff68]

A little painful to get to the first time you do it...but in Eclipse/Windriver-Workbench, on the left hand side, you should (depending on configuration) see two panes - one that's about projects and one that's about targets. You had to create one of these targets in the beginning in order to deploy the first time....

If you right-click on the target, you should see a "Connect" command in the menu. Connect. Then there will be a cascade of items that are found under that connected target. Now right-click on the target again and goto 'Target Tools' -> Target Console ... and when the dialog comes up, you can simply click "OK". You'll get a black text console which looks a lot like a cmd/dos-box. This is the netconsole.

bob

[programmerB]

what do I do when i get into the netConsole?

[bob.wolff68]

You'll want to report (copy/paste) what it says for bootup. It may give some clues to the folks that were asking.

bob

[programmerB]

ok sorry but i am really new at this i could reall use a full step by step

[Alan Anderson]

If you don't understand how to follow the step-by-step set of instructions that Bob already posted, I don't know what else would help you. You'll probably be best served by finding a local resource to show you in person. I don't have a good feel for how long it takes to get around the Los Angeles area, but there must be more than a dozen teams within shouting distance of you.