|
|
|
 I told people that I was a summit for world leaders for our regional. We had two that are current world leaders and over 1000 that will be ones in 2029. - Foster [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I told people that I was a summit for world leaders for our regional. We had two that are current world leaders and over 1000 that will be ones in 2029. - Foster [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
05-04-2012, 00:21
|
||||
|
||||
|
Re: Autodesk Inventor Sheet Metal Question
(first off, this probably should have been made in the inventor subsection)
If I remember correctly (haven't use inventor in a few years so I may be running on old info) you have to set it up to load the settings from the correct save file. The settings you have set may be loading from the wrong save file when you open a new file. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode