|
|
|
 FIRST, grant me the serenity to accept the things I cannot drill, Courage to drill the things I can, And wisdom to know the difference. - Bill_B [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST, grant me the serenity to accept the things I cannot drill, Courage to drill the things I can, And wisdom to know the difference. - Bill_B [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
new bosch pinion and mounting
Does anyone have an idea about mounting the Bosch motor this year. Are the small pin insets on the sides capable of taking a tap? Notice the face is no longer tapped for mounting? Just looking for other ideas beside clamping the motor's body.
Anthony Team 221 --> 857 |
|
#2
08-01-2003, 17:16
|
|||||
|
|||||
|
The lowest risk way of mounting the drill motors is clamping around the sleeve. I rly, RLY wouldn't tap any hole in a motor casing, even if it does look like it could take a tap.
btw- are you speaking of the bosch drills or the vendor>? Last edited by DaBruteForceGuy : 08-01-2003 at 17:53. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
