|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
|
I suppose that 3 days is enough time to wait for FIRST to upload the spec sheet for the Chiaphua Motors.
I got this directly from Chiaphua (knowing motor manufacturer's by name is worth something ;-) Hope this helps. Joe J. |
|
#2
|
|||||
|
|||||
|
/me bows to the god.
|
|
#3
|
||||
|
||||
|
Thanks!
THANK YOU!!!
- Katie |
|
#4
|
|||
|
|||
|
Chiaphua motor spec
Something seems wrong with the spreadsheet: it claims 300 oz-inch torque from the motor at stall.
Doesn't that seem just a tad high, like 10 or 20x ?Team #492 |
|
#5
|
||||||
|
||||||
|
I think is it right.
|
|
#6
|
||||||
|
||||||
|
Re: Chiaphua motor spec
Quote:
|
|
#7
|
|||
|
|||
|
Doh
That would explain the 10-20x error .... ;^)
|
|
#8
|
||||
|
||||
|
Re: Chiaphua motor spec
Quote:
|
|
#9
|
||||
|
||||
|
Everyone is ahead of me.
I also thought that seemed high and went here to post the same question that Larry did, only to find out I can't read! oz-inches are not foot -pounds Thanks all And a HUGE thanks to Joe!!!!! Eric |
|
#10
|
||||
|
||||
|
bah, I can't find any other specs, can I get some linkage?
like for the other motors. . . i found them the other day, but couldn't find them again . . . . |
|
#11
|
|||
|
|||
|
Quote:
www.team696.org/motorspecs.html |
|
#12
|
||||
|
||||
|
wow... old thread heh
|
|
#13
|
|||||
|
|||||
|
Note; this thread is from last season.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Training: Interpreting Motor Spec Sheets presentation wanted | kmcclary | Motors | 3 | 11-11-2003 17:26 |
| Matching Drill and Chiaphua | sanddrag | Motors | 12 | 17-01-2003 11:23 |
| Coupling the Chiaphua & a variable Drill output | Jeff Sharpe | Motors | 9 | 13-01-2003 20:21 |
| sheet rubber | Adams High Man | OCCRA | 1 | 20-10-2002 10:07 |
| Chiaphua gearing (Chippy and Bosch) | honky | Motors | 3 | 31-01-2002 10:28 |