Arduino and kop encoder

[Michael Hill]

Originally Posted by SeanPerez

it may only count once, but i was getting around 8000 rpm.


with your new code, the faster it spins, the lower the rpm.

Are you looking at the first column?

If you are, disregard that. That's the "dt" value. Sorry, I didn't make it very legible. Look at the second set of numbers.

0.43 RPM: 2803.74 Pot: 82

means that 0.43 is the time between calculations, 2803.74 is the revolutions per minute, and 82 is the potentiometer value.