|
|
|
 Corrected, math isn't my strong point (I went to art school for a reason) - KelliV [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Corrected, math isn't my strong point (I went to art school for a reason) - KelliV [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
10-01-2003, 09:09
|
||||||
|
||||||
|
Working on it
Matt,
I am 90% sure it is the same pitch, but some of the over pin dimensions indicate that it may be a 0.75 (yes, it does exist). I am now resorting to the age old method of running the motor against 0.7 Mod and 0.75 Mod gears to see which one is better. My worste fear is that it is a 0.7 module with a longer addendum (notice the pointy teeth), which means that will may have a hard time finding gears that fit right. Standard center distances may not apply. -Paul |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trade - have Bosch gearboxes, need motors | Andy Baker | Motors | 0 | 24-01-2003 08:32 |
| Bosch motors | archiver | 2001 | 1 | 23-06-2002 23:08 |
| Chiaphua gearing (Chippy and Bosch) | honky | Motors | 3 | 31-01-2002 10:28 |
| Bosch Extrusion | Tony G. | Technical Discussion | 4 | 11-01-2002 19:04 |
| Bosch Extrusion | Tony G. | Technical Discussion | 0 | 10-01-2002 10:26 |
Threaded Mode