Helical gears that come with new drill motor

If you never takes steps to solve problems you cannot just complain that they exist. - Wayne C. [more]

		Chief Delphi > Technical > Technical Discussion
Helical gears that come with new drill motor

Thread Tools

Rate Thread

Display Modes

11-01-2003, 19:07

Joe P

Registered User

#0647

Join Date: Feb 2002

Location: Killeen, Texas

Posts: 43

Helical gears that come with new drill motor

The kit comes with those helical gears that have 1/16" wide keyway and the 5/8" shaft with 1/8" wide keyway. I see the key stock for this application. Is this key stock good enough to hold these helical gears in place on the 5/8" shafts, or do I need to use a collar or something else to prevent the gears from sliding axially along the shafts?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Has any one stuck a drill motor in the FP trans?	Lotownvw	Motors	15	21-04-2003 23:57
drill motor mounts- again	Jeff Sharpe	Motors	6	07-04-2003 23:20
A new record for breaking a drill motor	ZacharyD	Technical Discussion	23	16-01-2003 16:58
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
Drill Motor and FP Motor Shaft Diameters	Andy Baker	Motors	4	11-06-2001 20:12

All times are GMT -5. The time now is 13:54.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.