|
Re: Press Fit
This year we had our chassis water-Jet. There was no problem press fitting into it when i made the hole the exact size. NOTE: we also had it painted so that may have affected it). But when we got our off-season Chassis laser cut it was also press fitted and stayed perfectly (wasn't Painted). you shouldn't have a problem with 0.09", as long as you have a support all around the outside of the sheet-mteal and bearing, so that the metal doesn't bend. we had that happen, but we just hammers it back in place :/
__________________
Hall of Fame Team 1114 Simbotics
2013-Present
Host of Simbot Solidworks Series
Team 772 Sabre Bytes
2010-2013
Dean's List Finalist 2013 Waterloo Regional
|
Sometimes an aggravating season is the most educational. - Al Skierkiewicz [more] 
Hybrid Mode
