|
|
|
 Isn't that sort of like asking "is that an African or European swallow?" - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Isn't that sort of like asking "is that an African or European swallow?" - dlavery [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: Solidworks WCP gears
|
|
#2
13-07-2012, 16:02
|
||||
|
||||
|
Re: pic: Solidworks WCP gears
|
|
#4
13-07-2012, 16:44
|
||||
|
||||
|
Re: pic: Solidworks WCP gears
I used the extruded cut tool to create the tooth gap then just patterned the teeth. Using gear formulas to determine the rest using the design table in Solidworks.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
team 1671
Linear Mode
