|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||||
|
||||||
|
RoboEmu's interface is 100% gtk+/gnome. These are both available for Jaguar, so the changes needed to RoboIDE should be minimal. If OSX supports POSIX commands (ioctl, etc), you shouldn't need to change ANYTHING in the RoboIDE source to get it to compile. If you decide to give this a try and run into troubles, give me an email or a PM and I'll see if I can help.
--Rob |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mac? | AlbertW | Chit-Chat | 9 | 29-03-2003 21:01 |
| Mac Programming | tiskippy | Programming | 2 | 12-02-2003 00:08 |
| Pneumatics electrical wiring and programming | archiver | 2001 | 1 | 23-06-2002 23:10 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
| pbasic programming | punarhero | Programming | 4 | 21-01-2002 23:32 |