|
|
|
 It sounded like a good idea, and then I thought about it. :-/
- Wetzel [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It sounded like a good idea, and then I thought about it. :-/
- Wetzel [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
16-08-2012, 07:15
|
|||
|
|||
|
Re: Encoder with CAN for Drive Train
I looked again and found the gyro angle input. I was looking for a gyro refnum during the Open.
The gyro input has a default of 0 if not wired, so not wiring it shouldn't be a problem. Wiring in a changing value would cause a changing orientation, even when you were sending in 0,0,0. So that is another good vector to test on the robot. Greg McKaskle 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode