Quote:
Originally Posted by AdamHeard
I think if this was built as a rigid gantry system versus held by hands and then also improved the detail/resolution of the "reading" it could work on production machines. The .001" level easily achievable, .0001" much harder.
The hackaday community doesn't quite understand engineering tolerances/precision. A comment in post discussing this router mentioned that .003" tolerance required temperateure, humidity control, etc...
|
I can't imagine you'd get below .001" without some serious changes. .0001" is hard enough on some full size mid range machines.
Having 75% of the drive train without direct connection to the transmission would make me a bit queasy, but then again, I'm not Winnovative. - Taylor [more] 
Hybrid Mode
