|
|
|
 the robot is never done that it just evolves less rapidly - sporno [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| the robot is never done that it just evolves less rapidly - sporno [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#1
|
|||
|
|||
|
[FTC]: Encoder cables
Does anyone know what is the easiest way to extend the encoder cables (or replace them by a longer ones) - short of cutting in the middle and soldering in 4 new wires?
USdigital which produces the encoders used by TETRIX motors sells these replacement cables which can be oredered in any length: http://usdigital.com/products/cables.../CA-MIC4-SH-NC but the other end is unterminated, so we need to also find the 4-pin connector that plugs into the motor controller. Anyone has doen this before? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode