Orientation device

[Jon Stratis]

I wanted to add this, from the 2012 Inspection checklist:

Unauthorized Wireless Communication – no wireless communication to/from robot or operator console without FIRST permission. Laptop wireless (WiFi and Bluetooth) disabled. No radios allowed on the operator console or in the pit<R55, R84, Admin Section 4.3.1 >

[dtengineering]

There are specific, fixed points on the field (and in the ceiling above the field) that emit light. It may be possible to use a camera to track orientation.

Just don't ask me to write the code for it!

Jason

[ToddF]

Extrapolating from Jason's idea of using ambient light, there are also ambient radio waves being transmitted from fixed locations around the field. Though wireless communications are not permitted, there isn't any rule against passively detecting sources of transmitted radio waves. Just like a cell phone can triangulate it's location from cell towers, it might be possible to triangulate robot position and orientation. You could use one of your practice matches to drive around the field and make a calibrated map.

It would be a heck of an engineering challenge, though. The necessary equipment might also put you way over budget.

Todd F.

[Gdeaver]

As dtengineering suggested the lights in the ceiling would provide a frame of reference outside the robot. A magnetometer also provides a frame of reference outside the robot. Triangulation with a radio transmitter also provides this. Of the 3 the mag is the least difficult. Our team is looking at using 9 degrees of freedom. A mag, an accelerometer, and a gyro with sensor fusing algorithms. The big problem is the mag and the hard and soft iron distortions. We did some testing in September with our 2011 robot. The 2011 robot is ideally suited for a mag. there is very little ferrous metal or motors up high. Our 2012 robot has no area on it with out magnetic distortions. If we use this we will have to design the robot with it in mind. The latest generation of Gyros has improved allot. I feel that field centric robot control with out operator intervention is now possible. It does take allot of effort.

[Bryce Paputa]

you might be able to do something like an optical mouse (or multiple ones), I wouldn't be sure how though, and it might not work if the field isn't flat. you could even use something like a mechanical mouse, you could just have some omniwheels with encoders, you should be able to figure it out with 4? you might need more and it would probably take a lot of DIO channels, but i think it would be possible.