|
|
|
 Go get Al, he probably isn't busy! - Jimmy Nichols [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Go get Al, he probably isn't busy! - Jimmy Nichols [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
15-11-2012, 15:06
|
||||
|
||||
|
Re: New Talon Speed Controller
Using a custom PWM signal generator, I have run the Vic888 with periods from 5ms to 20ms, and with pulse widths from .5ms to 2.5ms with no problems. I believe I did the same with the Talon, also with no problems. [edit] I have not tested whether the motor controllers would calibrate properly to this pulse width range [/edit] Last edited by Ether : 15-11-2012 at 16:05. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode