[FTC]: Possibility of encoder mounts on regular axles

I, for one, refused to be railroaded down this train of thought so easily! Geeze, one lousy game hint just builds up steam for any old picture to come through and go two pages in a matter of hours. - Billfred [more]

		Chief Delphi > Other > FIRST Tech Challenge
[FTC]: Possibility of encoder mounts on regular axles

Thread Tools

Rate Thread

Display Modes

17-11-2012, 19:30

andidani

Registered User

FTC #4970

Join Date: Sep 2012

Location: United States

Posts: 3

andidani is an unknown quantity at this point

[FTC]: Possibility of encoder mounts on regular axles

Hello, I'm a part of an FTC team in Virginia. As a part of our design, we have a joint powered by a single continuous rotation servo. In order to more accurately move it, we were wondering if it would be possible to mount a DC motor encoder in some way onto a standard, approximately 3/16" inch axle connected to the aforementioned axle.

Has anyone tried anything similar or have any ideas on the matter?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 18:26.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.