Quick Optical Sensor Question

[crazycliffy]

Specs on sensor say:
Off-State leakage current: less than 50 uA @30V
On-State Saturation Voltage: less than 1V @10 mA, less than 1.5V @ 100mA

When you played around with the sensor,
do you recall what the actual voltage produced was
that goes into the digital input on the robot controller?

e.g. If I supplied 12 V power to the sensor...
For ON position, is voltage at output 5V or 0V ?
For OFF position, is voltage at output 5V or 0V ?


Do you know if these Banner Sensors, can detect a analog
signal, something that ranges between 0 and 5 V?

Anyone try it out?




FYI.