|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#14
|
|||
|
|||
|
Re: 2583 Off-Season Drivetrain Help
I have included a link for the .step file of the chassis now
I included a lot of the changes you guys suggested I still have to include the rest of the electronics and figure out a tensioning design but that will come later The red things on the wheels are the colson live axle hubs http://wcproducts.net/wcp-00053/ The blue things on the aluminum channel (seen from the bottom of the robot) are AndyMark hex bearings with flanges http://www.andymark.com/product-p/am-0279.htm The hole in the aluminum channel is slightly smaller than the OD of the bearing so they will be pressed in and there is a small flange on the bearing which will keep it from going too far. Also the axle is now hex and the pulley has a hex bore so they are connected Do you guys have any more comments or suggestions? Your help has been very useful so far, im learning a lot Download Link: http://www.2shared.com/file/kdrucknG/chassis1.html ![]() ![]() ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|