New Talon Speed Controller

[Mike Copioli]

Originally Posted by Ether

Mike, could it be done with a PWM signal generator which generates a known pulse width accurate to 0.001 ms ?

No. Joe's questions was regarding factory calibration. These settings are what the firmware saves to flash when the Talon is first programmed. These settings are over written once the user performs a successful calibration.

A user calibration could be performed to obtain values that are are close or even the same as what's saved during initial programming. But there would be no way for the user to confirm this.

We did not feel the ability to restore factory calibration was necessary since the procedure would not be much different than performing a user calibration. And a user calibration will yield the best performance.