|
|
|
 First off, let me suggest that you read the rules! There is an amazing amount of really good information in them. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| First off, let me suggest that you read the rules! There is an amazing amount of really good information in them. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
16-12-2012, 17:19
|
||||
|
||||
|
Re: Step by Step Hole Reaming Instructions
I'm looking to doing the same, machining 1-1/8 inch holes to a tight tolerance. I've been looking in to either a "sheet metal cutter" which can do 1/4" (e.g. http://www.trick-tools.com/Sheet_Metal_Cutters_81) or an annular cutter with a weldon shank adapter for our R8 mill.
I'd like to know if anyone with machining experience could comment on the above? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode