|
|
|
 A pole is usually made of aluminum or steel pipe. You can get these wherever you get metal. :)
As for polls, there's a check box in the "Additional Options" section of the New Thread page that you can click to create said poll. - Chris is me [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
17-12-2012, 11:42
|
||||
|
||||
|
Re: pic: New to CADing for FRC. Critique? Would this work?
Increase the diameter of the standoffs that hold the sides together. Doing so will distribute the shock load better and also provide more surface area to help stiffen the side plates when your assembly is tighten. If you added a bend along the leading edge that would help and you could add some brackets between the side plates to keep the plates parallel and square
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode