|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#4
|
|||
|
|||
|
Re: [FTC]: Tetrix Servo Joint Pivot Brackets
Are you using 485 servos? The brackets pictured were designed for the 475 servos, which were just a little bit thinner than the 485s. We have found that we have to bend the servo bracket open just a little bit (and then back to parallel, just farther apart), and then the pivot bracket open just a little bit, to make it all work. I don't think you want to enlarge the whole on the back of the servo bracket.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|