|
|
|
 Don't be too arrogant as to think that just because you didn't invent it, it is not useful. - ptan [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't be too arrogant as to think that just because you didn't invent it, it is not useful. - ptan [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
17-01-2003, 16:45
|
|||||
|
|||||
|
We have had good experances with set screws on flattend shafts, we actually had this setup on a vandoor at full stall and it never came loose.
But I would get some 1/2" steel and make an coupler before I would buy one. Its really not that hard to do if you think about how its made. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Globe Motor | archiver | 2000 | 0 | 24-06-2002 00:15 |
| So you want to stall a Globe Motor... | archiver | 2000 | 1 | 24-06-2002 00:09 |
| Globe Motors & other FIRST Suppliers at Design Show | archiver | 1999 | 2 | 23-06-2002 22:07 |
| Lead screws or globe motors, anyone? | archiver | 1999 | 3 | 23-06-2002 21:52 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
Threaded Mode