|
|
|
 I think we must take seriously the importance of "infecting" the rest of the world with this passion. - Tstone [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I think we must take seriously the importance of "infecting" the rest of the world with this passion. - Tstone [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
29-12-2012, 16:48
|
||||
|
||||
|
Re: pic: WCD
Just one thing on the DT, I can't see but I just want to make sure you have the bearing blocks really well connected inside the tube. On a prototype last year we just had 3/8 plate on each side with spacers and they would wouldn't always be lined up correctly.
Besides that the drive looks like a run of the mill WCD and I'm sure it'll work if it's made well. As for the electronics, what's supporting the PD board? It looks like it's just on 1/8 polycarb. You might want to think about supporting it because it looks like it'll bounce around a lot and that might looses up connections. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode