Circular/cornerless robot - Bumper free or fully bumpered?

[DonRotolo]

Originally Posted by Richard Wallace

I think Brandon's right.^

So, assuming it must have bumpers, would a circular frame with <112 inch perimeter (i.e., <35.6" diameter) offer any advantage for Ultimate Ascent?

You could roll it sideways instead of using a robot cart?

Originally Posted by topgun

I am a little confused. So you are saying a completely round robot surrounded completely with a bumper would satisfy the rules? What about the numbering? I suppose just put at 90 degrees and call it good.

The other question is how to make a completely round bumper out of 3/4" wood material.

I think a circular bumper would pass inspection. I would pass it, as an inspector. Al S (THE Lead Robot Inspector) says so too.

To make such a bumper, make your own plywood. 1/16" strips of wood, steamed, glued and clamped will make a plywood circle. Ever see a bent-wood chair?

Leav, if you build that please post a photo! That would look awesome!