Simple CAD help

[MarkoRamius1086]

That is an option, though a loft of that nature with the existing geometry shown will give a solid cone on the end of the tube.

If however, you want your cone to be hollow as well, you can add an addtional circle in the middle of the existing one, in hopes that it creates the wall. If that does not work, it would not take long to do a Revolve Operation. In that case, simply draw and dimension the upper half of the wanted section view, draw the centerline, and apply the revolve feature.

I was just teaching some of our kids how to do those two different strategies today actually! There are many youtube videos of Inventor and SolidWorks on youtube, and both may be helpful due to the similar nature of the two programs. If those do not solve your questions in a timely manner you can always PM me or post again!

[Anthony Galea]

Thank you for the help everyone!

[inventor_phild]

I agree with the sketch > revolve work flow. Also, to hollow out the part, use the Loft command. Loft is high up on my coolest commands in Inventor list!

If you need further help, post me the dimensions and I can assist, although there is always a lot of great help from other teams on this forum.

[Anthony Galea]

Going further, The same part, when added to a full design, refuses to go to where I want it to.
This is where I put it, and then I save it:


Then when I save it, and then open up after closing it again, it just goes back to the original placement:

[Gray Adams]

Are you fully constraining it in place?

[Anthony Galea]

Originally Posted by Gray Adams

Are you fully constraining it in place?

Oh, that must be it. But it does not explain why a few other pieces are staying in place after a save...

[TVwazhere]

Depending on the constraint, you need 1 to 3 constraints to secure one part to another.

Could you zoom in on the part and also open up any constraints you have on the part thats moving?