2013 Pyramid Corner Gussets - Any interest in purchasing?

[AdamHeard]

Originally Posted by sanddrag

We have about $200 into just the pipe and tubing for the official version, minus the DOM spec. We bought standard welded seam tubing, since DOM was WAY more expensive, and not readily available.

To clarify, we will be producing the steel corner gusset plates only, not full welded corners. It's likely that the plates will cost in the neighborhood of $3 each. They might be 3/16 rather than 1/4 thick. Still working on details with our manufacturer. Should have it tomorrow.

We can produce the plywood gussets if there is sufficient interest, but I imagine most teams can fabricate their own.

Making them out of 3/16" is far less attractive to us.