Goal capacity - Chief Delphi

If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more]

		Chief Delphi > FIRST > General Forum
Goal capacity

Thread Tools

Rate Thread

Display Modes

07-01-2013, 13:12

Kims Robot Kims Robot is offline

Onto a New Chapter...

AKA: Kim O'Toole Eckhardt

no team

Join Date: Aug 2004

Rookie Year: 1996

Location: Framingham, MA

Posts: 1,467

Kims Robot has a reputation beyond repute

Re: Goal capacity

There are only 6 frisbees that count in that goal...

Also, you can check out some of my photos here: http://www.flickr.com/photos/kimsrob...7632447784120/
6 frisbees shouldn't have trouble fitting in, though robots that climb will have to be careful not to touch those frisbees or they won't count if I remember the rule right(though look it up, I only did a quick scan).

__________________
~kim~

Kimberly O'Toole Eckhardt <3
Principal Systems Engineer & Program Manager
History - Team 176, Team 229, Team 1511, FIRST Volunteer!!
My new FIRST Photography Hobby & Angry Eric's Fan Page
Excellence - is the result of caring more than others think is wise, risking more than others think is safe, dreaming more than others think is practical, and expecting more than others think is possible.

Last edited by Kims Robot : 07-01-2013 at 13:15. Reason: wrong high goal

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 06:53.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.