Simple CAD help

[Anthony Galea]

Going further, The same part, when added to a full design, refuses to go to where I want it to.
This is where I put it, and then I save it:


Then when I save it, and then open up after closing it again, it just goes back to the original placement:

[Gray Adams]

Are you fully constraining it in place?

[Anthony Galea]

Originally Posted by Gray Adams

Are you fully constraining it in place?

Oh, that must be it. But it does not explain why a few other pieces are staying in place after a save...

[TVwazhere]

Depending on the constraint, you need 1 to 3 constraints to secure one part to another.

Could you zoom in on the part and also open up any constraints you have on the part thats moving?