|
|
|
 You know what they call the graduate with the lowest GPA in med school? Doctor.
You know what they call the fourth robot in the alliance that wins Einstein? Champion. - Billfred [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Using Digi-Key Shaft Encoders
How would I go about programming one of these, and which one would be ideal for positioning a low speed (60 RPM) shaft? Any info is appriciated. Thanx.
Digi-Key Shaft Encoder Pages: http://dkc3.digikey.com/PDF/T031/0830.pdf http://dkc3.digikey.com/PDF/T031/0831.pdf http://dkc3.digikey.com/PDF/T031/0832.pdf Last edited by D.Viddy : 18-01-2003 at 23:42. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| If set screws suck . . . | Madison | Technical Discussion | 17 | 22-12-2003 19:19 |
| Who used wheel encoders | CyberWolf_22 | Technical Discussion | 12 | 04-05-2003 15:37 |
| Where to get shaft encoders | D.Viddy | Programming | 12 | 17-01-2003 09:38 |
| Motor coupling | archiver | 2001 | 19 | 23-06-2002 23:35 |
| Need Help on Shaft Mounting... | archiver | 2001 | 3 | 23-06-2002 23:29 |
Threaded Mode