|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
||||||
|
||||||
|
No, == is not a valid operator in PBASIC.
Goya's third post hit the nail on the head: if you don't SERIN, you don't get any new data. As for what makes an expression a condition is the presence of any of the following operators: = >(=) <(=) <> Note that = can also be used for assignment. It's function is determined by the context in which it is used. For example: if rc_sw1=1 then ... uses = as a comparison operator, whereas rc_sw1=1 uses = as the assignment operator. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Actual execution time measurement | Dan | Technical Discussion | 5 | 24-03-2003 11:36 |
| How long is one stamp loop | yangotang | Programming | 3 | 23-01-2003 20:36 |
| NEED HELP with Delay loop for compressor relay switch | archiver | 2001 | 10 | 24-06-2002 02:11 |
| Counter loop | archiver | 2001 | 3 | 24-06-2002 00:44 |
| OK...so I'm totally out of the loop... | Markfuscius | 3D Animation and Competition | 8 | 03-02-2002 02:39 |