Gears for the CIM motor shaft not going on.

Umm, guys, the stacking game was last year. Toss the Genia is much more appropriate for Aim High. - Greg Marra [more]

		Chief Delphi > Technical > Technical Discussion
Gears for the CIM motor shaft not going on.

Thread Tools

Rate Thread

Display Modes

10-01-2013, 20:37

MrBasse

Registered User

FRC #3572 (Wavelength)

Team Role: Coach

Join Date: Jul 2011

Rookie Year: 2010

Location: Norton Shores, MI

Posts: 679

Re: Gears for the CIM motor shaft not going on.

We put our gears in the oven for a bit around 300 degrees and then use a drill press to push them on. We don't have an arbor press in our shop... Heat is wonderful thing when fitting close fitting parts, just remember not to touch them with bare hands for a while after doing this.

__________________
Andrew Basse
Coach - FRC Team 3572 - Wavelength

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.