Using an Non First Microcontroller with Victor 884 Motor Controller

I think all drivers will be required to wear tights! - Mike Martus [more]

		Chief Delphi > Technical > Electrical
Using an Non First Microcontroller with Victor 884 Motor Controller

Thread Tools

Rate Thread

Display Modes

14-01-2013, 15:47

miker4004

Registered User

FRC #4004

Join Date: Jan 2013

Location: MI

Posts: 2

miker4004 is an unknown quantity at this point

Re: Using an Non First Microcontroller with Victor 884 Motor Controller

My understanding is this:
1ms - 2ms pulse width with 1.5ms being center(off) , the 1ms full rev and 2ms being full fwd.
refresh rate or period is 50hz. signal level is a ?. It seem that 5volts was the output but I know that we had issues with some RC type outputs being to weak to drive one.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:56.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.