|
|
|
 Remember, just because you saw it on ChiefDelphi, doesn't make it true. - Karthik [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Remember, just because you saw it on ChiefDelphi, doesn't make it true. - Karthik [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Issues with servo
hy guys we are having some troubles with the servo library and the Servo motor we don't know if we are getting the wrong vi's or the motor isn't working
we use this squeme Open>Set ref>Get>Set angle 
|
|
#2
17-01-2013, 07:21
|
|||
|
|||
|
Re: Issues with servo
Check the digital breakout board. You need a jumper next to the PWM to provide the correct voltage to the servo -- unfortunately. Also, make sure to run the DS and enable the robot.
Greg McKaskle Last edited by Greg McKaskle : 17-01-2013 at 07:22. Reason: one more thing
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
