RPM control system - Chief Delphi

I have yet to see an error where disabling the watchdog was the correct decision. - EricVanWyk [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
RPM control system

Thread Tools

Rate Thread

Display Modes

17-01-2013, 09:41

propionate propionate is offline

Team co-lead and LabVIEW programmer

AKA: Stephen

FRC #1732 (Hilltopper Robotics)

Join Date: Jan 2012

Rookie Year: 2009

Location: Milwaukee

Posts: 93

Re: RPM control system

You don't have to use the encoder - just wire up the inductive sensor to a DIO input, and have LabVIEW pretend it is an encoder. The encoder VI will generate a speed for you (degrees/second), but you will likely have to scale it to get the correct RPM. Once again, this is just an alternative to using the Counter method.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 21:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.