CIM->Victor 884->Arduino not working

If all else fails - bring cookies in the shape of FIRST shapes. Cookies are always good. - Eugenia Gabrielov [more]

		Chief Delphi > Technical > Programming
CIM->Victor 884->Arduino not working

Thread Tools

Rate Thread

Display Modes

#21

17-01-2013, 15:47

BitTwiddler BitTwiddler is offline

electronics/programming mentor

AKA: Mr Tanguay

FRC #1726 (N.E.R.D.S.)

Team Role: Mentor

Join Date: Oct 2008

Rookie Year: 2006

Location: Sierra Vista, AZ

Posts: 254

Re: CIM->Victor 884->Arduino not working

Quote:

That's what I got on the o scope. I put a 10 ohm resistor in line with the signal wire and took the voltage above and below the resistor then hooked the other channel on the o scope to a constant 0.1v and used the math function to multiply the channels

Forgive me for asking the obvious question but are both probes set to the same gain (x10, x1)?

Last edited by BitTwiddler : 17-01-2013 at 15:49.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.