|
|
|
 If I thank everyone that I want to, we might be here for a while - Karthik [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| If I thank everyone that I want to, we might be here for a while - Karthik [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Code deploying problem
So i've been trying to deploy my code to a practice robot and the cRIO is all imaged fine and everything. I try to run/deploy code to it and it says "Connection failed. The network address might be invalid or the target is not responding". We've checked and double check our IP but I could still be doing something wrong. I didn't see anyone else with this problem
|
|
#2
17-01-2013, 00:11
|
||||
|
||||
|
Re: Code deploying problem
When you created the project, did you enter the correct address for your cRIO?
|
|
#3
17-01-2013, 06:25
|
|||
|
|||
|
Re: Code deploying problem
Can you successfully run RobotMain using the Run button?
Greg McKaskle
|
|
#4
17-01-2013, 16:10
|
||||
|
||||
|
Re: Code deploying problem
try to reboot the cRIO via driver station
|
|
#5
17-01-2013, 16:38
|
|||
|
|||
|
Re: Code deploying problem
i've fixed it, it was the wrong address, i entered 10.30.08.2 before but i changed it to 10.30.8.2 and it worked so that one zero was messing it up
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
