VEX Pro vs. AM Bearings

*quick grab the epoxy we can rebuild him, make him stronger than before* - amos229 [more]

		Chief Delphi > FIRST > General Forum
VEX Pro vs. AM Bearings

Thread Tools

Rate Thread

Display Modes

#24

18-01-2013, 11:32

Paul Copioli Paul Copioli is offline

President, VEX Robotics, Inc.

FRC #3310 (Black Hawk Robotics)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 2000

Location: Rockwall, TX

Posts: 1,392

Paul Copioli has a reputation beyond repute

Re: VEX Pro vs. AM Bearings

Richard,

Remember that we increased the size of the hex in order to accommodate various larger hex stock. If used with the VEXpro shaft there could be as much as .001 gap between the flats of the hex shaft and flats of the bearing

The only true way to get runout indication is clamping the output and rotating the input.

We will perform this test on samples this Monday.

__________________
In full disclosure I am the President of VEX Robotics, a division of Innovation First International.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 15:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.