help in basic building

[Aroki]

Originally Posted by safiq10

okay on the woodscrews we use if u over power the power drill then try to put a wood screw in then the screw head will go from a phillips to a no head. Any idea on how to install these easier

As a general rule you don't run the drill at full power when putting screws into wood, so go slow and don't over tighten, and remember to keep firm pressure downward so the bit doesn't slip out of the screw and strip it.

Also your drill may have a the ability to set how much torque it has, if it has a dial with numbers (usually like 1-20) you can lower that number so it can't go in to far (look at the drill on the left in fox46's picture for reference)

[fox46]

That comes back to buying high quality fasteners. But aroki is correct. Your drill should have a torque limiting clutch.

[safiq10]

Our season just ended and i want to thank all of thouse who helped me i lost hoped but you guys helped me find it. So to that my 1st year is over now its time to head into off season