|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
When I startup my Labview and choose new project, what template do I choose?
![]() |
|
#2
|
|||||
|
|||||
|
Re: Labview Help
Start with Arcade Drive Robot - hardware or simulation
|
|
#3
|
||||
|
||||
|
Re: Labview Help
that isnt an option, here are my options:
Blank Project Blank VI Simple Slate Machine Queued Message Handler Actor Framework Finite Measurement continuous measurement and logging feedback evaporative cooler instrument driver project labview FPGA control on compact rio Labview FPGA Project labview waveform and aqquisition and logging labview realtime control robotics project which is it? |
|
#4
|
||||
|
||||
|
Re: Labview Help
I've never had something similar to those options before, but if anything it's because I would assume you didn't update your labview and driverstation with the updates located here.
https://decibel.ni.com/content/docs/DOC-26315 |
|
#5
|
|||||
|
|||||
|
Re: Labview Help
That means you haven't installed everything you need for FRC.
The Kit DVD was just the start. Now you need to apply the Updates on this page: http://www.usfirst.org/roboticsprogr...ical-Resources LabVIEW Utilities Update (required for all Teams) LabVIEW Updates (only for Teams programming in LabVIEW) P.S. I like the page that Cyrus posted. Last edited by Mark McLeod : 21-01-2013 at 15:03. |
|
#6
|
||||
|
||||
|
Re: Labview Help
this what my startup looks like, is this normal?
|
|
#7
|
|||||
|
|||||
|
Re: Labview Help
That's not the FRC startup window.
Go to Tools -> Choose Environment then you should get the choice shown in the first attachment below. Pick LabVIEW for FRC and click the box to Make this my default setting, then Apply. We normally see the second attachment: Last edited by Mark McLeod : 21-01-2013 at 15:28. |
|
#8
|
||||
|
||||
|
Re: Labview Help
i click on the shortcut, Labview 2012. it sais launch labview, i click. the page i posted comes up
|
|
#9
|
|||||
|
|||||
|
Re: Labview Help
Did you install the FRC LabVIEW updates linked in the earlier posts?
Does Tools -> Choose Environment show you any choice other than LabVIEW? |
|
#10
|
||||
|
||||
|
Re: Labview Help
yes
|
|
#11
|
||||
|
||||
|
Re: Labview Help
wait, its looking normal now, it just didnt register the updates, i installed them like 30 seconds ago
|
|
#12
|
||||
|
||||
|
Re: Labview Help
so which templaate do I choose again?
|
|
#13
|
|||||
|
|||||
|
Re: Labview Help
Under New use FRC cRIO Robot Project to start with new robot code.
Use FRC Dashboard Project if you want to start modifying the default Dashboard. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|