|
|
|
 The moral of this story is that constructive criticism is good, but only as long as you don't act like a complete idiot. - David Kelly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The moral of this story is that constructive criticism is good, but only as long as you don't act like a complete idiot. - David Kelly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Code Will Not Load
I have set up the robot hardware (cRIO, D-Link, Driver Station) according to the "Getting started with the 2013 control system" document on the FIRST website. However, when I open up the Driver Station Application, the "communications" light is green, but the code will not show up. I have checked the options in windriver under Window->Preferences->FIRST Dowloader Preferences, and when I hit FIRST->Deploy, the code acts as though it is deploying to the robot, but the Driver Station always says there is no code on the cRIO. Does anyone know what could be causing this?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode