|
|
|
 A programmer's job is to write documentation that happens to compile.... :) - buddy.smith [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A programmer's job is to write documentation that happens to compile.... :) - buddy.smith [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
23-01-2013, 06:40
|
||||
|
||||
|
Re: KoP ToughBox Mini and CIMs Problem/Solution
Turning it around in the gearbox suggests that the cim motor fasteners may be drilled / tapped off center. We've used minitoughboxes each of the last several years and not had that problem.
It was noted a couple days ago that one team saw differences between the Vexpro hex bearings and the AndyMark ones. For those teams effected, are you using Andymark Hex shaft? AndyMark Bearings? Vexpro Cims? Finding a common factor might help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode