|
|
|
 Kit wheel? Someone probably has them. N-tooth IFI sprocket? You might get lucky. Part Made By A Local Company When You're Competing 800 Miles Away? Bring three. - Billfred [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: pic: FRC 3184's drop test results 2
We use a similar connector from a different vendor, I wonder what it would have looked like had the connectors been pinned to the extrusion instead of just pressed in.
|
|
#2
23-01-2013, 19:23
|
||||
|
||||
|
Re: pic: FRC 3184's drop test results 2
Some of the connectors appear to have sheared in the other picture, so it doesn't seem like press fitting vs screw/pin fitting would make a difference.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
